Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
- 10. Brake system
   10.1. Technical characteristics
   10.2. Adjustment of provision of a pedal of a brake
   10.3. Main cylinder of a brake
   10.4. Brake mechanism of a forward wheel of the Teves brand
   10.5. Brake mechanism of a forward wheel of the GIRLING brand
   10.6. Brake disk
   10.7. Case of a bracket and piston
   10.8. Drum-type brake mechanism of a back wheel
   10.9. Brake drum
   10.10. Wheel brake cylinder
   10.11. Disk brake mechanism of a back wheel
   10.12. Pressure regulator
   + 10.13. Parking brake
   10.14. Anti-blocking system of brakes (ABS)
   10.15. Pumping of brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



10.6. Brake disk

Check of a condition of working surfaces of a brake disk

PERFORMANCE ORDER
1. To raise a forward part of the car and to remove a wheel (see subsection 10.4).
2. To clear a brake disk.
3. To measure by a calliper thickness of a disk. Minimum admissible thickness of a disk is specified in Technical characteristics. If thickness of a disk of less admissible, a disk it is necessary to replace.
4. At existence рисок the disk can be removed and прошлифовать, but taking into account that its final thickness was not less admissible. It is recommended to replace brake disks from both parties. Face palpation of a working surface of a disk should be no more than 0,06 mm.

Prevention

Condition of working surfaces of a brake disk to check without removal of a disk from the car.


Removal and installation

PERFORMANCE ORDER
1. To raise a forward part of the car and to remove a wheel (see subsection 10.4).
2. To unscrew two bolts of fastening, to remove a brake bracket in collecting and to suspend it on a wire to a body, watching that the brake hose was not overwound and did not test excessive loadings.
3. For convenience of further installation of a brake bracket it is recommended to remove previously brake shoes (see subsection 10.5).
4. To remove a brake disk.
5. To establish a brake disk upside-down. Before installation to clear being interfaced surfaces of a nave of a wheel and a brake disk. To wrap two bolts of fastening of a brake bracket the moment of 70 N · m (7,0 kgfs · м). After installation to press several times a brake pedal for piston installation into position.