Audi 100

1982-1990 of release

Repair and car operation




Audi 100
- 1.1. Governing bodies and devices
   + 1.1.1. Release models till January of 1988 g
   + 1.1.2. Release models since January of 1988 g
   1.2. Window regulators with the electric drive
   1.3. An external rear-view mirror with the electric drive
   1.4. Internal rear-view mirror
   1.5. Cowl
   1.6. Forward seats with mechanical adjustment
   1.7. Forward seats with the electric drive
   1.8. Transportation of lengthy subjects
   + 1.9. Engine start
   1.10. Precautionary measures at an engine stop
   1.11. Cruise control
   1.12. Heating and ventilation
   1.13. Control panel conditioner
   1.14. Board computer
   1.15. Management of the board computer on release models till January, 1988.
   1.16. Blocking of the internal handle of the lock of a back door
   1.17. Car running in
   1.18. Car check before departure
   1.19. Replacement of operational liquids and lubricants
   + 1.20. Servicing of cars of release till August, 1985.
   + 1.21. Servicing of cars of release since August, 1985.
   1.22. Periodicity of greasing of knots of the car
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



1.14. Board computer

GENERAL INFORMATION

Command keys the board computer on release models since January of 1988 g

1–key of a choice of function;

2–key of zeroing of data;

3–lever of the switch of a screen wiper

The display of the board computer on release models since January of 1988 g

1–function indicator;

2–display;

3–tachometer;

4–function index

The board computer is built in a combination of devices. It has two command keys which have been taken out on models of release till January, 1988 in the central part of the dashboard (see poses. 33 on fig. The dashboard of models of release till January of 1988 g), and on release models since January, 1988 – on the lever of the switch of a screen wiper (see poses. 28 on fig. Dashboard of models of release of c of January, 1988).

For switching of functions to press the top or lower part of a key 1 (see fig. Command keys the board computer on release models since January of 1988 g). Thus the indicator 1 (see fig. The display of the board computer on release models since January of 1988 g) shows the chosen function. By each pressing of a key function following one after another joins. By pressing a key of 2 Reset (see fig. Command keys zeroing of data of the chosen function in "memory" of the computer occurs the board computer on release models since January of 1988 g) more than 2 with.

Functions of the board computer

Fuel consumption (the computer with this function establish on cars without a turbo-supercharging). Shows fuel consumption at present in km l/100. The computer counts fuel consumption through each 30 m of a way. After a stop of the car the last value kept in "memory" is highlighted. On fuel consumption the computer starts to show reliable information after passing by the car of 40 m of a way. By pressing an accelerator pedal on the motionless car with working engine the computer also shows unreliable information (the increased fuel consumption) in the absence of data on the passable way.

Pressure of pressurization of air (the computer with this function establish on cars with the MS model engine instead of fuel consumption function)

Shows the pressure of pressurization developed by a turbokompressor, in a range from 0 to the 2nd a bar.

Course stock on the fuel which has remained in a tank

Shows distance in kilometers which the car can pass on the remained fuel at constant style of driving. This size pays off proceeding from fuel consumption for the last 30 km of a way. At settlement run less than 50 km (a fuel reserve in a tank) the computer is automatically switched to this function with any other. Thus the figure on the display starts to blink. After in a tank there are less than 5-8 l of fuel, instead of size of a stock of a course the indicator "L" (an empty tank) lights up. To disconnect warning signal, it is necessary to press the Reset key. If in a tank there was a reserve stock of fuel, at each inclusion of ignition the warning signal will be automatically highlighted.

Amount of the spent fuel

Shows spent from the moment of engine start amount of fuel in liters. After ignition switching off the last value remains in memory of the computer. At repeated inclusion of ignition after the car passed 30 m, old value is erased from "memory" and settled an invoice fuel consumption anew. Value can be nulled by Reset key pressing during 2 pages.

Movement time

Shows time of finding of the car in movement from the moment of the last zeroing of data. At the switched-off ignition value remains in "memory" of the computer and at further movement this value is summarized with movement time after a stop. Value can be nulled by pressing the Reset key during 2 pages. After movement during 2 h (with stops less than 10 mines) the computer is automatically switched to this function with any other. Thus the figure on the display starts to blink (it is recommended to stop off for rest). At a stop less than 10 mines with not switched off ignition the warning signal joins again in 2 h (time of a stop is considered as movement time). At a stop more than 10 mines with the switched-off ignition the signal joins in 2 h after a start of motion. To disconnect warning signal, it is necessary to press the Reset key.

Average fuel consumption

Shows average fuel consumption from the moment of the last zeroing of data. At the switched-off ignition value remains in "memory" of the computer. Value can be nulled by pressing the Reset key during 2 pages. Before the car passed the first 30 m, the computer shows zero. After 24 h the computer begins new counting.

Average speed of movement

Shows average speed of movement from the moment of the last zeroing of data. At the switched-off ignition value remains in "memory" of the computer and at further movement this value is considered as average speed of movement after a stop. Value can be nulled by pressing the Reset key during 2 pages.