Audi 100

1982-1990 of release

Repair and car operation




Audi 100
- 1.1. Governing bodies and devices
   + 1.1.1. Release models till January of 1988 g
   + 1.1.2. Release models since January of 1988 g
   1.2. Window regulators with the electric drive
   1.3. An external rear-view mirror with the electric drive
   1.4. Internal rear-view mirror
   1.5. Cowl
   1.6. Forward seats with mechanical adjustment
   1.7. Forward seats with the electric drive
   1.8. Transportation of lengthy subjects
   + 1.9. Engine start
   1.10. Precautionary measures at an engine stop
   1.11. Cruise control
   1.12. Heating and ventilation
   1.13. Control panel conditioner
   1.14. Board computer
   1.15. Management of the board computer on release models till January, 1988.
   1.16. Blocking of the internal handle of the lock of a back door
   1.17. Car running in
   1.18. Car check before departure
   1.19. Replacement of operational liquids and lubricants
   + 1.20. Servicing of cars of release till August, 1985.
   + 1.21. Servicing of cars of release since August, 1985.
   1.22. Periodicity of greasing of knots of the car
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



1.15. Management of the board computer on release models till January, 1988.

GENERAL INFORMATION

Command keys the board computer on release models till January of 1988 g

1–key of switching of functions;

2–key of zeroing of data

The display of the board computer on release models till January of 1988 g

1–function indicator;

2–computer display;

3–tachometer;

4–function index

For switching of functions to press the top part of a key 1 (see fig. Command keys the board computer on release models till January of 1988 g). Thus the indicator 1 (see fig. The display of the board computer on release models till January of 1988 g) will show the chosen function. By each pressing of a key function following one after another joins. By pressing the lower part of a key 1 (see fig. Command keys the board computer on release models till January of 1988 g) join an electronic clock. By pressing a key of 2 Reset during more than 2 with there is a zeroing of data of the chosen function in "memory" of the computer.

Computer functions

Functions of the computer are similar to computer functions on release models since January, 1988 except that instead of function «amount of the spent fuel» the electronic clock function is established.

Electronic clock

Shows the current time. For inclusion of this function to press the lower part of a key 1 (see fig. Command keys the board computer on release models till January of 1988 g). At ignition switching off the computer is automatically switched to this function with any other which is restored at the subsequent inclusion of ignition. For transfer of hours to press the lower part of a key 1 and to hold it until indication of minutes will start to blink. Then to press a key of 2 Reset for transfer of minutes. By each short-term pressing there is a transfer for one minute. If to hold a key of 2 Reset in the pressed condition, transfer of minutes occurs quicker. Again to press the lower part of a key 1 and to hold it until indication of hours will start to blink. To put clock similarly to minutes. After transfer of time to press the top part of a key 1.