Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
- 3. Engines
   - 3.1. Four-cylinder engines
      3.1.1. Removal and engine installation
      + 3.1.2. Dismantling and engine assembly
   + 3.2. Five-cylinder engines
   + 3.3. Diesel engine
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



3.1.1. Removal and engine installation

PERFORMANCE ORDER
1. To establish the car over a viewing ditch so that the engine was under a waist or other similar device loading capacity not less than 300 kg.
2. To disconnect a wire from the "minus" plug of the storage battery located in a water-proof casing on the right (on the cars equipped with the conditioner, the storage battery is located under a back seat).
3. To remove a cowl (cм. subitem 1–6 subsections 11.3).
4. To disconnect from the thermostat case taking-away hose of a radiator, to remove a stopper from a broad tank and to merge cooling liquid (see subitem 1–3 subsections 4.1).
5. To unscrew drain jams in a case of the engine and a case of a transmission and to merge oil.
6. To unscrew drain jams in a case of the engine and a case of a transmission and to merge oil.
7. To disconnect electric wires from the sensor of turning on of the electrofan and from the fan of system of cooling.
8. To remove a radiator (see subitem 3–9 subsections 4.6).
9. To disconnect from the fuel pump hoses of giving and the return fuel plum (cм. subsection 6.1.5 item 2).
10. To disconnect wires from knots and the elements of electric equipment established on the engine.
11. To disconnect from the carburetor vacuum hoses and management cables.
12. To remove the air filter (cм. subitem 1–6 subsections 6.1.2).
13. On cars with the conditioner to remove the compressor, without disconnecting hoses, and to fix it a wire on a body.
14. On cars with the hydraulic booster of a steering to remove the pump, without disconnecting hoses, and to fix it a wire on a body.
15. To remove a heatinsulating guard of the right support of the engine.
16. To disconnect a reception pipe of the exhaust silencer from a flange of a final collector (cм. subsection 5.1 item 1).
17. Slightly to weaken an inhaling of a nut of fastening of the right arm of an engine mount.
18. To remove a starter (cм. subitem 1–3 subsections 12.1.4.1).
19. To disconnect a reception pipe of the exhaust silencer from a transmission arm.
20. To turn out the bottom bolts of fastening of a transmission to the engine.
21. To unscrew bolts of fastening and to remove the lower part of a case of coupling.
22. Slightly to weaken an inhaling of a nut of fastening of the left arm of an engine mount.
23. On cars with an automatic transmission to unscrew bolts of fastening of the hydrotransformer.
24. To substitute under a transmission a jack or other suitable support.
25. To unscrew bolts of fastening of a transmission to the engine.
26. To disconnect a wire of "weight" of the engine.
27. To check, whether all hoses and electricity cables are disconnected from the engine.
28. To unscrew nuts of fastening of the left and right arms of the engine and to hang out the engine by means of a waist.
29. To remove engine mount arms.
30. To take out the engine from a motor compartment. On cars with automatic transmission to fix the hydrotransformer in a coupling case that it did not drop out.
31. To establish the engine upside-down. On cars with a mechanical transmission before installation of the engine to grease with a thin layer of konsistentny greasing of a shlitsa of primary shaft of a transmission.