Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
- 4. Cooling system
   4.1. Replacement of cooling liquid
   4.2. Replacement and thermostat check
   4.3. Removal and installation of the water pump
   4.4. Check and replacement of the sensor of turning on of the electrofan
   4.5. Replacement of the sensor of temperature of cooling liquid
   4.6. Removal and installation of a radiator of system of cooling
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



4.6. Removal and installation of a radiator of system of cooling

PERFORMANCE ORDER
1. To disconnect a wire from the "minus" plug of the accumulator.
2. To merge cooling liquid (see subitem 1–3 subsections 4.1).
3. To disconnect bringing (3) (see fig. System of cooling of the 4-cylinder engine) or (20) (see fig. System of cooling of the 5-cylinder engine) and taking-away (9) or (13) hoses of a radiator.
4. To disconnect a hose going from a broad tank to a radiator, to remove a tank.
5. To disconnect conducting from the engine of the fan, the sensor of temperature of cooling liquid and the sensor of turning on of the fan.
6. To unscrew from below bolts of fastening of a radiator.
7. To unscrew bolts of fastening of the top casing 22 or the 9th radiator and to remove it.
8. To unscrew bolts of fastening of a radiator from above and a nut from below approximately in the middle if it is.
9. To take out a radiator with a casing of the fan and the fan up.
10. To establish a radiator upside-down. Before installation of a radiator to check and if are worn-out to replace rubber plugs of fastening of a radiator and the buffer. At installation of a casing of a radiator to track, that the cable of a drive of the lock of a cowl passed through the corresponding opening.