Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
- 6. Power supply system
   - 6.1. Power supply system of carburetor engines
      6.1.1. Replacement of a filtering element of the air filter
      6.1.2. Removal and installation of the air filter
      6.1.3. Temperature regulator check
      6.1.4. Check of the valve of a temperature regulator
      6.1.5. Removal and installation of the fuel pump
      6.1.6. Check of pressure of forcing of the fuel pump
      6.1.7. Removal and installation of a cable of a drive of an accelerator
      6.1.8. Adjustment of a cable of a drive of an accelerator
      6.1.9. Fuel level sensor replacement
      6.1.10. Removal and installation of a fuel tank
      6.1.11. Replacement of the filter of thin purification of fuel
      6.1.12. Removal and carburetor installation
      + 6.1.13. Dismantling and carburetor assembly
      + 6.1.14. Pierburg 1B3 carburetor adjustments
      + 6.1.15. Pierburg 2Е2 carburetor adjustments
      + 6.1.16. Keihin carburetor adjustments
   + 6.2. A power supply system of engines with fuel injection
   + 6.3. Power supply system of the diesel engine
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



6.1.3. Temperature regulator check

GENERAL INFORMATION

Depending on ambient temperature or depression the temperature regulator operates a stream of the warm or cold air submitted to the carburetor. Damage of a temperature regulator will lead to interruptions at increase in frequency of rotation of a cranked shaft of not heated-up engine, to increase of fuel consumption and an obmerzaniye of an inlet pipe of the engine. Check a temperature regulator on the cold engine. Zaslonka (see fig. The air filter) should turn freely, without jammings.

PERFORMANCE ORDER
1. To weaken a collar and to remove from a temperature regulator branch pipe a hose. To check the provision of a zaslonka. The opening of supply of warm air should be blocked.
2. To remove the filter from the carburetor (see subsection 6.1.2).
3. To connect a hose to the carburetor, having put on it a branch pipe instead of a hose.
4. To start the engine and let's to it work idling. Zaslonka should turn and open access to warm air.
5. To disconnect from the carburetor a hose. Zaslonka should turn and block access to warm air. If it does not occur, to replace a temperature regulator.