Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
- 6. Power supply system
   - 6.1. Power supply system of carburetor engines
      6.1.1. Replacement of a filtering element of the air filter
      6.1.2. Removal and installation of the air filter
      6.1.3. Temperature regulator check
      6.1.4. Check of the valve of a temperature regulator
      6.1.5. Removal and installation of the fuel pump
      6.1.6. Check of pressure of forcing of the fuel pump
      6.1.7. Removal and installation of a cable of a drive of an accelerator
      6.1.8. Adjustment of a cable of a drive of an accelerator
      6.1.9. Fuel level sensor replacement
      6.1.10. Removal and installation of a fuel tank
      6.1.11. Replacement of the filter of thin purification of fuel
      6.1.12. Removal and carburetor installation
      + 6.1.13. Dismantling and carburetor assembly
      + 6.1.14. Pierburg 1B3 carburetor adjustments
      + 6.1.15. Pierburg 2Е2 carburetor adjustments
      + 6.1.16. Keihin carburetor adjustments
   + 6.2. A power supply system of engines with fuel injection
   + 6.3. Power supply system of the diesel engine
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



6.1.4. Check of the valve of a temperature regulator

GENERAL INFORMATION

The temperature regulator valve (see fig. The air filter) operates a zaslonka. At the faulty valve there can be interruptions in operation of the engine idling in a warming up mode, interruption at increase in frequency of rotation, the engine develops insufficient capacity, fuel consumption increases. The valve check on the cold engine. Zaslonka should turn easily, without jammings. On the warm engine depending on ambient temperature access of warm air should be blocked partially or completely.

PERFORMANCE ORDER
1. To remove the filter, without disconnecting hoses (5) and (17).
2. To start the engine and to leave to idle.
3. To disconnect a hose from the valve. Zaslonka should block supply of warm air.
4. To put on the valve a hose. Zaslonka should open access to warm air.
5. To disconnect a hose. Zaslonka should turn and block access to warm air. If it does not occur, the valve means is faulty.