Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
- 7. Transmission
   - 7.1. Coupling
      7.1.1. Technical characteristics
      7.1.2. Coupling removal
      7.1.3. Survey and defektovka of details of coupling
      7.1.4. Coupling installation
   + 7.2. Mechanical drive of switching off of coupling
   + 7.3. Hydraulic drive
   + 7.4. Transmission
   + 7.5. Drive of forward wheels
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

работа в Москве

7.1.3. Survey and defektovka of details of coupling

1. To clear of a dust and dirt press and conducted disks, and also a working surface of a flywheel.
2. To examine a conducted disk. Cracks on details of a conducted disk are not allowed. To check wear of frictional slips. In case heads of rivets are deepened on distance less than 0,2 mm, the surface of frictional slips is greasy or zaklepochny connections, a conducted disk are weakened (or frictional slips) it is necessary to replace. To check reliability of fixing of dempferny springs in nests of a nave of a conducted disk, at the broken springs it is necessary to replace a disk. To check palpation of a conducted disk if at visual survey its buckling is revealed. If palpation exceeds 0,4 mm (it is measured at distance of 2,5 mm from an external edge of a disk), it is necessary to replace a disk.
3. To examine working surfaces of a friction of a flywheel and a press disk, having paid attention to absence deep рисок, nadirs, забоин, obvious wear tracks and an overheat. Weakening of zaklepochny connections of details of a press disk is not allowed. In the presence of the specified defects it is recommended to replace knots. To check a buckling of a press disk, having put a metal ruler to its working surface. If щуп in the thickness of 0,3 mm it is possible to insert in any place under a ruler, to replace press a disk with a casing assembled.
4. External survey to estimate a condition of a diafragmenny spring of a press disk. Places of contact of petals of a spring with the bearing of switching off of coupling should be in one plane and not have obvious wear tracks.
5. To check ease of moving in the axial direction of a conducted disk of coupling on shlitsa of primary shaft. At the complicated moving to remove agnails with шлицов. Radial люфт a disk on a shaft it is not allowed.