Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
- 7. Transmission
   + 7.1. Coupling
   - 7.2. Mechanical drive of switching off of coupling
      7.2.1. Replacement of the bearing of switching off of coupling
      7.2.2. Adjustment of a free wheeling of a pedal of coupling
   + 7.3. Hydraulic drive
   + 7.4. Transmission
   + 7.5. Drive of forward wheels
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



7.2. Mechanical drive of switching off of coupling

7.2.1. Replacement of the bearing of switching off of coupling

GENERAL INFORMATION

Coupling with a mechanical drive

1–a conducted disk;
2–press disk assembled;
3–plug;
4–bolt;
5–bearing of switching off of coupling;
6–the directing plug;
7–lever of a fork of switching off of coupling;
8–bolt;
9–returnable spring;
10-fork of switching off of coupling;
11-adjusting plug;
12-lock-nut;
13-cable cover;
14-coupling pedal;
15-spring clamp

Installation of the lever of a fork of switching off of coupling

1–lever of a fork of switching off of coupling;

2–persistent plug of a cable

PERFORMANCE ORDER
1. To remove a transmission.
2. To remove by means of a screw-driver spring clamps from both parties of a holder of the bearing of switching off of coupling.
3. To remove the bearing of switching off of coupling from the directing plug.
4. To take out the bearing of switching off of coupling from a holder, having removed previously fixing brackets.
5. To establish in a holder the new bearing of switching off of coupling and to fix among themselves both parts of a holder fixing brackets.
6. To establish the bearing of switching off of coupling assembled with a holder on directing plug.
7. To fix the bearing on a fork of switching off of coupling, having established two spring clamps.
8. To check operability of a returnable spring. The fork of switching off of coupling under its influence should move the bearing towards a transmission case.
9. To check distance from the lever of a fork of switching off of coupling to the persistent plug of a cable of a drive of coupling. It should be 185 mm. Thus the pedal of coupling should be released. If this distance differs from specified, it is necessary to rearrange the lever on shlitsa of a shaft of switching off of coupling.