Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
- 9. Steering
   9.1. Technical characteristics
   9.2. Steering wheel
   + 9.3. Steering column
   9.4. Steering mechanism
   9.5. Adjustment of the mechanism of a steering
   9.6. Steering draft
   9.7. Pump of the hydraulic booster of a steering
   9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering
   9.9. Pumping of system of the hydraulic booster of a steering
   9.10. Driving belt of the pump of the hydraulic booster
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



9.2. Steering wheel

GENERAL INFORMATION

Steering column

1–decorative slip;
2–steering wheel;
3–nut;
4–nut;
5–a block with wires;
6–washer;
7–spring;
8–bearing;
9–podrulevy switches;
10-pipe;
11-arm of a steering column;
12-top shaft of a steering;
13-plug;
14-plastic plug;
15-bottom shaft of a column of a steering;
16-collar;
17, 18, 21 – bolts;
19-arm;
20-the ignition switch with the anti-theft device

Prevention

On the cars completed with a safety cushion, the steering wheel can be removed only at service stations.


Removal

PERFORMANCE ORDER
1. To disconnect a wire from the "minus" plug of the storage battery.
2. To establish forward wheels in the provision of movement of the car on a straight line.
3. To remove a decorative slip and to disconnect from it a block with wires of the switch of a sound signal.
4. To mark a relative positioning of a steering wheel and a shaft of a steering column.
5. To unscrew a nut of fastening of a steering wheel on so many that its end face was aflush with an end face of a shaft of a steering column.
6. Shaking for spokes, with force to pull on itself a steering wheel so that it descended from shliyets of a steering shaft. To unscrew finally a nut and to remove a washer and a steering wheel.

Installation

PERFORMANCE ORDER
1. Before installation to check, that forward wheels were in the provision of movement of the car on a straight line and the lever of the switch of indexes of turn was in neutral situation. Thus the rychazhok of shutdown of indexes of turn should be sent to the left side.
2. To establish a steering wheel on a shaft according to earlier made label.
3. To establish a washer and to wrap a nut of fastening the moment of 40 N · m (4,0 kgfs · м).
4. To insert coal contact to a wire into a nave of a steering wheel.
5. To connect a block with a wire to a decorative slip and to establish an overlay for a steering wheel.
6. To check distance from a casing of a steering wheel to a casing of podrulevy switches which should be equal 3 mm. If this distance differs from specified, to weaken fastening of podrulevy switches through an opening located from below in a casing of podrulevy switches. To expose the demanded distance and to fix podrulevy switches.
7. To make a trial trip. At car movement on direct spokes of a steering wheel should be located horizontally. Otherwise to remove a steering wheel and to establish it anew.