Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
- 9. Steering
   9.1. Technical characteristics
   9.2. Steering wheel
   - 9.3. Steering column
      9.3.1. A steering column with system of passive safety of PROCON-TEN
   9.4. Steering mechanism
   9.5. Adjustment of the mechanism of a steering
   9.6. Steering draft
   9.7. Pump of the hydraulic booster of a steering
   9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering
   9.9. Pumping of system of the hydraulic booster of a steering
   9.10. Driving belt of the pump of the hydraulic booster
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



9.3. Steering column

Removal

PERFORMANCE ORDER
1. To disconnect a wire from the "minus" plug of the storage battery.
2. To remove a steering wheel (see subsection 9.2).
3. To weaken fastening of podrulevy switches through an opening located from below in a casing of podrulevy switches. To remove podrulevy switches from a pipe of a steering column, having disconnected a block with wires.
4. To remove a combination of devices (see subsection 12.1.5.15).
5. Through an opening in the panel of a combination of devices to drill a drill in diameter of 3,5 mm a bolt of fastening of the case of the switch (lock) of ignition with the cut-off head.
6. To take away drafts and from the steering mechanism, having removed an arm and a clamping plate.
7. To unscrew a bolt of fastening of a coupling collar of the bottom shaft of a steering column, to shift a collar up and to disconnect the bottom shaft from a shaft of a driving gear wheel of the mechanism of a steering.
8. To turn out screws of fastening and to remove the bottom shelf from the driver.
9. To remove воздуходув for обдува feet of the driver.
10. To unscrew a bolt of fastening of a collar, having disconnected a shaft of a steering column from a shaft of a driving gear wheel of the mechanism of a steering. On models with a steering column without the hydraulic booster previously to shift a protective casing.
11. To unscrew two nuts and to take out two bolts of fastening of a steering column to an arm.
12. To lower a little steering column and to remove the case of the switch of ignition, having disconnected from it blocks with wires.
13. To take out a steering column through an opening in the dashboard.

Installation

PERFORMANCE ORDER
1. To establish a steering column upside-down.
2. Thus the top and bottom shaft of a steering column are compressed against the stop. To hold shaft in such situation, it is recommended to remove previously воздуходув for обдува feet of the driver.
3. Before connection of a shaft of a steering column with shaft of a driving gear wheel of the mechanism of a steering to insert into the ignition switch a key and to disconnect the anti-theft device.
4. The bolt of the 17th fastening of a collar is tightened by the moment of 25 N · m (2,5 kgfs · м), and two bolts of the 18th fastening of a steering column – the moment of 35 N · m (3,5 kgfs · м).