Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
- 9. Steering
   9.1. Technical characteristics
   9.2. Steering wheel
   + 9.3. Steering column
   9.4. Steering mechanism
   9.5. Adjustment of the mechanism of a steering
   9.6. Steering draft
   9.7. Pump of the hydraulic booster of a steering
   9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering
   9.9. Pumping of system of the hydraulic booster of a steering
   9.10. Driving belt of the pump of the hydraulic booster
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


работа в Москве



9.6. Steering draft

Removal

PERFORMANCE ORDER
1. To brake the car the parking brake and to establish an emphasis under back wheels.
2. To weaken two bolts of fastening of bent for to a gear lath (cм. fig. Steering mechanism). Thus the car should stand on wheels in order to avoid damage of a gear lath of the mechanism of a steering.
3. To weaken an inhaling of bolts of fastening of a wheel.
4. To raise and establish on a support a forward part of the car.
5. Finally to unscrew bolts of fastening and to remove a wheel.
6. To unscrew a nut of fastening of a tip with the spherical hinge.
7. Выпрессовать a finger of the spherical hinge from the rotary lever. It is recommended to do it by a stripper.
8. Finally to unscrew bolts of fastening and to remove draft or with a clamping plate.
9. For replacement of a tip of steering draft to weaken a lock-nut and to unscrew a tip, considering thus number of turns in order that at assembly to establish a tip in demanded situation.

Survey and defektovka of details of steering draft

PERFORMANCE ORDER
1. Attentively to examine steering draft. The worn-out and deformed drafts are not under repair and are subject to obligatory replacement.
2. If the antisplash cover of the spherical hinge has cracks or rubber lost elastic properties, a cover to replace.
3. If the spherical hinge has notable radial and axial люфты (it is checked at the established draft on the car) or the tip has люфт, with the spherical hinge it is necessary to replace a tip.

Installation

PERFORMANCE ORDER
1. To wrap a tip on the carving coupling on the number of turns counted up at removal.
2. At replacement of steering draft to expose length of new draft by means of the carving coupling, equal to length of old draft, and to fix lock-nuts.
3. To establish draft and a new clamping plate on an arm and to wrap fastening bolts, without tightening.
4. To press a finger of the spherical hinge in the rotary lever and to tighten a new nut the moment of 60 N · m (6,0 kgfs · м).
5. To establish a wheel and наживить bolts of its fastening.
6. To lower the car on the earth and to tighten finally bolts of fastening of a wheel the moment of 110 N · m (11,0 kgfs · м).
7. Finally to tighten bolts of fastening of bent for to a gear lath the moment of 60 N · m (6,0 kgfs · м). To bend short moustaches of a clamping plate.
8. To check a convergence of wheels at service station.